Videos




Using the Truemill certified series of cutters from SwiftCarb results in amazing increases in productivity.  The patent pending TRUEMILL CERTIFIED SERIES ENDMILLS were built specifically to optimize TRUEMILL'S patented cutter paths.

Check out the videos below and see these tools in action.
 
rampmilldemoSwiftCarb Rampmill
This video shows the new Swiftcarb Patent Pending Coolant-Through Rampmill in several configurations.
 
RampMill_Titanium_6AL4VThe SwiftCarb RampMill in Titanium 6AL4V9 (Short)
Our Patent Pending coolant through Swiftcarb Rampmill pulls 9.1 cubic
inches per minute removal rate in 6Al4V Titanium. (Short Version)
 
RampMill_Titanium_6AL4V
The full six minute video of  the revolutionary new SwiftCarb RampMill create multiple pockets a full one inch deep in Titanium 6al4v at a serfice footage rate of 550 sfm pulling 9 cubes.
 
SwiftCarb Rampmills are truely revolutionary!
SwiftCarb Rampmills are truely revolutionary!  Ramp into your part without pre-drilling and cut at incredible speeds.  Even if your vendors GIVE you the end mills you are using now, you are loosing money by not using RampMill for these operations.
 
<< Start < Prev 1 2 Next > End >>

Page 1 of 2